Adhesive 502 is a mixture of chemical composition capable of adhering super-fast, ultra-reliable, it is widely used in life as well as in labor and production, bringing enormous benefits. However, because of the use of glue 502 has caused some confusion for users such as 502 glue stick is hands or clothes .... So if this is the case, they must solve it like, check out the following share our.

1. How to handle natural glue stick 502

How to handle 502 natural glue stick when hands were soaked them in soapy water to soften however we require you to soak them as soon as possible, prevent glue stains were stuck too long to work use.

In addition you can also add a little vinegar mixed into this mixture to completely removing the glue stick 502 on hand. With this treatment can work or not, depending on the time and amount of glue in hand. If you do it this way has yet been wound glue remover then dried them and made some continued following way.

2. What to do when the 502 was glued with Acetone

Everyone knows Acetone is a chemical used to remove detergent or paint nails, hand dish but using acetone to soften the adhesive cyanoacrylate in the 502 not everyone knows. If your case was glued arm 502 may be used Acetone poured directly on hand to cleanse it. For this method you note can not be used because it could spy cotton reactive substances with cyanoacrylate glue in 502. In particular you will not use Acetone was poured into open wounds or sensitive skin areas such as the eyes , nose, mouth ...

3. What to do when the 502 was glued with sandpaper / wash

Treatments are only used 502 glue on the surface of items such as clothing, shoes ... even if used on your skin should be careful because if rubbing will cause damage to the skin. Instead of using sandpaper when 502 adhesive glue on your skin can soak them in hot water and then use pumice stone to rub, so traces of glue 502 will easily come apart.

4. What to do when the 502 was glued with butter

This is a method of adhesive remover 502 is quite simply butter and spread a layer of glue on the spot, do constantly until soft 502 glue stains, you can wash them with water is.

5. What to do when the 502 was glued with a mixture of acetone with WD40 (anti-rust oil)

If these methods are not effective, you can perform the following methods of us. The reason WD40, also known as anti-rust oil can be combined with Acetone Acetone evaporates rapidly since. Mixing the two mixtures with ratio of 1: 1 and then applied to the site of the 502-adhesive glue, we will provide you with immediate effect. Hopefully the above will help to share the experience you had handled 502 glue themselves more effectively.